hi,
Draw in 3D-space isn´t quite so easy, though I ´d guess it´s just a child´s play. I´ve problems with drwaing a line (axis) or with relocating a circle (limitation) in Z-level. Ortho-mode cannot help. So my thought was to measure the position first, then to write down this and to enter all three axis. Can I shift incrementally at all or just input a placeholder for example x?y? Z20 so that only is to shift in z and the other axis are´nt set to zero instead be ignored? (Example: Circle lies on x20, y30, z0 – shall shift to z20, now I enter x20, y30, z20, z20 works, x retains, y retains. Now I have a circle as a profile which I can neither measure nor catch with object snap. This is to shift.
Thanx
nikolaos
shift in z
- SUPPORT
- Site Admin
- Posts: 21
- Joined: 07.05.2006, 14:20
- Contact:
Re: shift in z
hello nikolaos,
It´s basically very simple. There are just 3 different input types.
1. Once the axis-values separated by commas (Autocad) e.g.: 120, 60, 30
2. The axis values with prefixed axis signs e.g.: x120, y60, z30 (arbitrary sequence)
if are not specified all axis the 3 remaining axis will be set with 0-value.
3. The incremental input e.g.: ix120 iy60 iz30. The axis designitions are prefixed an „I“ ( I for incremental) at the incremental input. The values refer to the previous point inputs (and are added)
Example for your proceeding:
- select circle
- activate „Translate“
- enter first point: enter „0“ or click to any other point in the drawing
- enter second point of Translation incrementally: „iz20“ and „Enter“
Best regards
It´s basically very simple. There are just 3 different input types.
1. Once the axis-values separated by commas (Autocad) e.g.: 120, 60, 30
2. The axis values with prefixed axis signs e.g.: x120, y60, z30 (arbitrary sequence)
if are not specified all axis the 3 remaining axis will be set with 0-value.
3. The incremental input e.g.: ix120 iy60 iz30. The axis designitions are prefixed an „I“ ( I for incremental) at the incremental input. The values refer to the previous point inputs (and are added)
Example for your proceeding:
- select circle
- activate „Translate“
- enter first point: enter „0“ or click to any other point in the drawing
- enter second point of Translation incrementally: „iz20“ and „Enter“
Best regards
3D-M-SOFT GmbH
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu