dear support team,
Since I dealed with the cam software long enough, still the question remains how to delete single holding tabs set up manualy? Somehow I cannot figure out.
Bye
Marcus
holding tabs
- SUPPORT
- Site Admin
- Posts: 21
- Joined: 07.05.2006, 14:20
- Contact:
Re: holding tabs
Hello Marcus
There are two possibilities:
1. For the deletion of single tabs just drag the tab „from the contour“.
2. Delete tabs all at once => The option „Place tabs automatically (Distance 'D')“ with distance „0“.
With kind regards, Bernd
There are two possibilities:
1. For the deletion of single tabs just drag the tab „from the contour“.
2. Delete tabs all at once => The option „Place tabs automatically (Distance 'D')“ with distance „0“.
With kind regards, Bernd
3D-M-SOFT GmbH
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu