Hello
i dont understand with my pocketing strategy no respecting my parameters total depth. i use the values total depth 12.5mm and step 2.5mm and the simulation total depth is 32mm.
thanks for your help
no respect total depth
- SUPPORT
- Site Admin
- Posts: 21
- Joined: 07.05.2006, 14:20
- Contact:
Re: no respect total depth
Hallo,
The total depth calculation is always made in Condacam from the height of the corresponding contour selected. The contour height can be ignored by specifying the start depth from which the "Total depth" will be calculated.
All dimension inputs relate to the original drawing dimensions in Condacam. In doing so the zero point position doesn´t matter.
Best regards...
The total depth calculation is always made in Condacam from the height of the corresponding contour selected. The contour height can be ignored by specifying the start depth from which the "Total depth" will be calculated.
All dimension inputs relate to the original drawing dimensions in Condacam. In doing so the zero point position doesn´t matter.
Best regards...
3D-M-SOFT GmbH
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu