no respect total depth

Post Reply
SD 31
Posts: 15
Joined: 05.12.2020, 13:20

no respect total depth

Post by SD 31 » 08.12.2020, 21:35

Hello

i dont understand with my pocketing strategy no respecting my parameters total depth. i use the values total depth 12.5mm and step 2.5mm and the simulation total depth is 32mm.

thanks for your help

User avatar
SUPPORT
Site Admin
Posts: 21
Joined: 07.05.2006, 14:20
Contact:

Re: no respect total depth

Post by SUPPORT » 09.12.2020, 13:28

Hallo,
The total depth calculation is always made in Condacam from the height of the corresponding contour selected. The contour height can be ignored by specifying the start depth from which the "Total depth" will be calculated.
Image

All dimension inputs relate to the original drawing dimensions in Condacam. In doing so the zero point position doesn´t matter.




Best regards...
Attachments
Totaldepth1.jpg
3D-M-SOFT GmbH
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu

SD 31
Posts: 15
Joined: 05.12.2020, 13:20

Re: no respect total depth

Post by SD 31 » 10.12.2020, 01:47

OK I understand thanks

Post Reply