allowance
Posted: 25.05.2021, 21:42
Hello
it's me again sorry
i would like to put allowance negative in my thread milling, and i use this toolshttps://www.sorotec.de/shop/Cutting-Too ... ng-cutter/
in the file this is how I program it for the M8/125 but i can't screw it.
i use a postpro eding cnc atc.
thanks you and sorry for my english is not my native langage and it's difficult for me.
it's me again sorry
i would like to put allowance negative in my thread milling, and i use this toolshttps://www.sorotec.de/shop/Cutting-Too ... ng-cutter/
in the file this is how I program it for the M8/125 but i can't screw it.
i use a postpro eding cnc atc.
thanks you and sorry for my english is not my native langage and it's difficult for me.