Hi!
Maybe I cannot see the wood for the trees. As far as I open a Nc-job the stock fades-in, which was hidden before.
How can I prevent this?
I open a Nc-job the stock fades-in
- SUPPORT
- Site Admin
- Posts: 21
- Joined: 07.05.2006, 14:20
- Contact:
Re: I open a Nc-job the stock fades-in
Hello Mercer,
Independent from the global showing/hiding state are all elements at the re-calculation fade-in that have already been activated compulsorily at the job creation. Diverse elements such as raw parts, models, boundary contours or select-contours have an influence on the job-creation. Suppose the user applied several raw parts or boundary contours in a great project. To keep the overview is difficult when many things overlap e.g if a boundary contour is effective at the recalculating (but which is not visible) and change the cutting path. When a job gets open all elements, belonging to this job, are inevitably activated as far as these elements are disenabled.
Kind regards,
Independent from the global showing/hiding state are all elements at the re-calculation fade-in that have already been activated compulsorily at the job creation. Diverse elements such as raw parts, models, boundary contours or select-contours have an influence on the job-creation. Suppose the user applied several raw parts or boundary contours in a great project. To keep the overview is difficult when many things overlap e.g if a boundary contour is effective at the recalculating (but which is not visible) and change the cutting path. When a job gets open all elements, belonging to this job, are inevitably activated as far as these elements are disenabled.
Kind regards,
3D-M-SOFT GmbH
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu