Hi
i installed the news version of condacam but i have a problem
if I modify a tool in an existing operation with a different profile tool, the profile of the new tool is not recognized in the simulation.
I my exemple i use a flat tools 10mm and the simulation is Conical/Roundhead mill.
Thanks you
not respect the tool shape
- SUPPORT
- Site Admin
- Posts: 21
- Joined: 07.05.2006, 14:20
- Contact:
Re: not respect the tool shape
Hello Stephane,
The project can be simulated correctly with us.
Sometimes this happens if you had not closed the simulation when changing the tool...
Best regards,
your Condacam-Team
The project can be simulated correctly with us.
Sometimes this happens if you had not closed the simulation when changing the tool...
Best regards,
your Condacam-Team
3D-M-SOFT GmbH
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu
Herrengrabenweg 31 | D-19061 Schwerin
Telefon: (0385) 61737343 | Fax: (0385) 61737355
www.condacam.eu | E-Mail: Info@condacam.eu
-
- Posts: 15
- Joined: 05.12.2020, 13:20
Re: not respect the tool shape
good morming condacam team
thanks you
it's good
thanks you
it's good